Marechal CS 75-250Amps Socket Outlets – 50 Volt Very Low Voltage LV Welding Connectors

Marechal CS 75-250Amps socket outlets have a current rating of 75A to 250A and a very low maximum voltage of 50V. CS 75-250Amps socket outlets have a bayonet contact system, self-cleaning contacts and 16 to 95sqmm conductors.

➡ View the complete range of High Current Plugs – 75A to 700Amps 1,000V electrical connectors for heavy power requirements.

Marechal CS socket outlets – Technical Specification

Type CS	Wiring (mm²)	In rated current (A)	i max welding cycle (A)
			5 min cycles
			60%	30%
CS2	16	75	100	150
	25	100	125	200
	35	125	150	250
	50	100	200	300
CS3	50	150	200	300
	70	200	250	350
	95	250	300	400

Marechal CS 75-250Amps Socket Outlets – 50 Volt Very Low Voltage LV Welding Connectors

MARECHAL HIGH CURRENT CONNECTOR TYPE CS

The CS’s single-pole connectors are designed for Extra Low Voltage applications (below 50 V a.c. ou 120 V d.c.). The connection and disconnection must imperatively be preformed off-load. Socket-outlet contacts are not protected (IP0X according to IEC/EN 60529 standard)

Warnings

These accessories must be installed by a qualified electrician, according to applicable installation standards and to the present instruction sheet
Use a conductor cross-section suitable for the load
The tightening torque must not be transmitted to the insulating part of the accessory. Maintain the rear of the contact with a suitable key while tightening
Respect tightening torques
These accessories must be used according to their designed destination, in a strict respect of the required operation of connection and disconnection
Marechal accessories must be used with Marechal complementary accessories only. Any repair or service must be achieved with genuine Marechal parts only
The cables must not exert any constraint on the accessories

Marechal CS 75-250Amps Socket Outlets – Install & Operation Guidelines

Install & Operation Guidelines

Strip the conductor according to the ferrule used.
Crimp the threaded lug or the ferrule with an appropriate die (NFC 20-130 or VDE 0220 or another). A double hexagonal crimping is recommended. For threaded lugs, do not crimp beyond the line.
Slide the neoprene sleeve so that the screw heads fit into the slots provided (CS2 and CS3), or the contact body fits into the groove (CS5). A small amount of wire pulling lubricant may make sliding easier.

Operation

Insert plug into receptacle or inlet into connector and rotate 1/4 turn clockwise until locked. Rotate anticlockwise to disconnect.